![]() Placement Before Constructing the DIY Boomf Boxīefore you start the next step, make sure your rubber band is located exactly as it is in the picture below. Then, line up the fold along the edge of the middle square and press in place. Using your finger is going to assure that your box will be messy with unwanted glue.Īpply Tacky Glue to the end flap as shown in the picture above. You want the corners to be sharp and hold their shape. ![]() ![]() It's also a good idea to spread the glue over the flap so the glue goes all the way to the edges. School glue would take way too long, but if you have patience, go for it. I tried using some Elmer's Glue-All, but it takes longer for the glue to set. I used the paper cutter to cut the outer edges and scissors to cut the angles in the middle section where the rubberband will sit.Īttach to the other half. Then, you can use scissors to cut out the boxes or use a paper cutter and scissors. This template includes two halves of the box to make one pop-up box. You can print numerous copies or cut them out and use the cutout to trace multiples. Directions:įirst, download and print the template. If you’re not sure if your cardstock is heavy enough, just try making one with it. Not sure if it was heavy enough, I just tried making one and it works nicely. *I used standard cardstock with 147 gsm, which I picked up at the local grocery store. Thanks for supporting this website!) Supplies Needed: (We are an Amazon affiliate and may receive a small percentage of any sales through the links in this post at no cost to you.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |